Installation

2UR-FSE ENGINE CONTROL SYSTEM: MASS AIR FLOW METER: INSTALLATION

HINT
When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.

1. INSTALL MASS AIR FLOW METER SUB-ASSEMBLY (for Bank 1)

(a) Install the MAF meter with the 2 screws.

Torque : 0.8 Nm (8 kgf-cm, 7 in-lbf)





NOTICE:
* If the screw is tightened excessively, the screw hole may be damaged.
* Make sure the O-ring is not pinched.

2. INSTALL MASS AIR FLOW METER SUB-ASSEMBLY (for Bank 2)

(a) Install the MAF meter with the 2 screws.

Torque : 0.8 Nm (8 kgf-cm, 7 in-lbf)





NOTICE:
* If the screw is tightened excessively, the screw hole may be damaged.
* Make sure the O-ring is not pinched.

3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY LH

(a) Install the air cleaner cap.

for hose clamp - Torque : 3.8 Nm (38 kgf-cm, 34 in-lbf)





HINT
Insert the protrusion of the air cleaner hose into the hole of the hose clamp.

4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY RH

(a) Install the air cleaner cap.

for hose clamp - Torque : 3.8 Nm (38 kgf-cm, 34 in-lbf)





HINT
Insert the protrusion of the air cleaner hose into the hole of the hose clamp.

5. INSTALL V-BANK COVER SUB-ASSEMBLY Installation