Removal

TIRE AND WHEEL: TIRE PRESSURE WARNING ECU: REMOVAL

NOTICE:
* When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the intelligent tester and write them down before removal.
* It is necessary to perform initialization Initialization after registration Registration of the transmitter IDs into the tire pressure warning ECU after the ECU and/or valve and transmitter has been replaced.

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal

2. REMOVE BATTERY SERVICE HOLE COVER LH Removal

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* When disconnecting the cable, some system need to be initialized after the cable is reconnected Repair Instruction - Initialization.
* After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

5. REMOVE INSTRUMENT SIDE PANEL RH Removal

6. REMOVE NO. 2 INSTRUMENT CLUSTER MOULDING Removal

7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

8. REMOVE LOWER INSTRUMENT PANEL Removal

9. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Removal

10. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal

11. REMOVE TIRE PRESSURE WARNING ECU





(a) Disconnect the ECU connector.

(b) Remove the bolt and ECU.