Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

(a) Check that the power switch is OFF.





(b) Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

(c) Install the airbag sensor with the 3 bolts.

Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)

NOTICE:
* If the center airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
* When installing the center airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the center airbag sensor.

(e) Connect the holder (with connectors).

(f) Check that the waterproof sheet is properly set.

2. INSTALL CONSOLE BOX ASSEMBLY

(a) w/ Rear Seat Entertainment System:

(1) Install the console box assembly Installation.

(b) w/o Rear Seat Entertainment System:

(1) Install the console box assembly Installation.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. INSTALL BATTERY SERVICE HOLE COVER LH Installation

5. INSTALL DECK TRIM SIDE BOARD LH Installation

6. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation

7. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Pinout Values and Diagnostic Parameters.