Installation

LIGHTING: STOP LIGHT SWITCH: INSTALLATION

1. INSTALL STOP LIGHT SWITCH

(a) Temporarily install the stop light switch with the lock nut.

NOTICE:
insert the stop light switch with a force of less than 17 N*m (170 kgf*cm 12 ft.*lbf).

(b) Rotate the stop light switch clockwise 90° to install it to the adjuster.





Standard:

1.5 to 2.6 mm (0.0590 to 0.102 in.)

NOTICE:
* When the stop light switch is rotated clockwise, make sure the stop light switch moves outward less than 1 pitch (pitch: distance between 2 screw threads).
* Rotate the stop light switch with a torque of 1.5 N*m (15 kgf*cm.13 in.*lbf).
* Do not allow silicon grease to contact the stop light switch.

(c) Connect the stop light switch connector.

2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation