Parking Assist System - Initialization Procedure
L-SB-0089-11September 1, 2011
Initialization of Advanced Parking Guidance System
Service Category
General
Section
Pre-Delivery Service
Market
USA
Applicability
Introduction
The Advanced Parking Guidance System assists the driver during parking and parallel parking by displaying an image of the area behind the vehicle and controlling the steering wheel with the vehicle in reverse.
When the DCC fuses are removed or battery terminal disconnected the power source to the steering angle sensor is cut off. When the DCC fuses are reinstalled or the battery terminal is reconnected the rear view monitor will operate but the steering angle sensor center position must be set through system initialization before park assist will become operational.
Initialize the Advanced Parking Guidance System after installing the DCC fuses during Pre-Delivery Service (PDS).
Any time the battery terminal has been disconnected, the Advanced Parking Guidance System MUST be initialized.
Warranty Information
Initialization Procedure
1. Start the vehicle and ensure the vehicle is in "READY" mode.
2. Check if the Advanced Parking Guidance System is operative by moving the shift lever to the "R" position.
"System initializing:" appears on the rear view monitor as shown in Figure 1.
3. Move the shift lever to the "P" position and turn the steering wheel lock to lock.
4. Move the shift lever to the "R" position.
When "Check surroundings for safety." appears on the rear view monitor as shown in Figure 2, the initialization of the Advanced Parking Guidance System has been completed.