Installation

L110F HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER POSITION SENSOR: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH

(a) Install the park/neutral position switch to the hybrid vehicle transmission assembly.

(b) Temporarily install the 2 bolts.





HINT
Fully tighten the bolts with the neutral alignment mark line aligned with the groove. [*1]

(c) Install a new lock washer and the nut.





Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(d) Temporarily install the control shaft lever with the nut.





HINT
Bend the tabs of the lock washer before fully tightening the nut. [*2]

(e) Turn the control shaft lever counterclockwise until it stops. Next, turn the control shaft lever clockwise 2 notches to set it to the N position.





(f) Remove the nut and transmission control shaft lever.





(g) Align the neutral alignment mark line with the switch groove, and tighten the 2 adjusting bolts. [*1]





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(h) Using a screwdriver, bend the tabs of the lock washer.





NOTICE:
Make sure that the nut is held firmly.

(i) Install the transmission control shaft lever with the nut. [*2]





Torque : 16 Nm (163 kgf-cm, 12 ft-lbf)

(j) Connect the park/neutral position switch connector.





2. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

(a) Move the shift lever to the N position and tighten the nut while lightly pushing the lever toward the R position.





Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

NOTICE:
Do not push the shift lever too hard.

3. INSTALL OIL COOLER TUBE

(a) Install the oil cooler tube with the 3 bolts in the order shown in the illustration.





Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. INSPECT SHIFT LEVER POSITION Adjustments

6. INSPECT PARK/NEUTRAL POSITION SWITCH POSITION Adjustments

7. ADJUST PARK/NEUTRAL POSITION SWITCH POSITION Adjustments

8. INSPECT SHIFT LEVER OPERATION Adjustments

9. INSTALL NO. 2 ENGINE UNDER COVER Installation

10. INSTALL FRONT FLOOR COVER CENTER Installation

11. INSTALL BATTERY SERVICE HOLE COVER LH Installation

12. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

13. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire) Installation

14. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation