Windows: Service Precautions

WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL SYSTEM: PRECAUTION

1. NOTICE FOR DISCONNECTING CABLE FROM NEGATIVE (-) BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):

After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal





2. POWER WINDOW CONTROL SYSTEM PRECAUTIONS

CAUTION:
* The power window control system prohibits the AUTO UP/DOWN function when the jam protection function malfunctions. Therefore, troubleshoot the power window control system after confirming that no diagnostic codes are displayed.
* When the power window regulator or the power window regulator motor assembly is replaced, the power window control system must be initialized.
* After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the AUTO UP function is used. In such cases, the AUTO UP function can be resumed by repeating the following operation at least 5 times:
(1) Close the power window by fully pulling up the power window switch and holding it at the AUTO UP position.
(2) Open the power window by fully pushing down the power window switch.
* The jam protection function may operate unexpectedly even when the power window control system is normal, due to detection of a different operation learned value when the door glass moving speed changes sharply under any of the following conditions:
(1) A power window being opened or closed while the vehicle is driving on a rough road.
(2) A power window being opened or closed while the door is being opened or closed.
(3) A sharp voltage change.
NOTICE:
Do not disconnect the battery while the power switch is ON (IG). Otherwise, DTC B2313 will be output.