Navigation System - HDD Map Update Process

L-SB-0003-13

January 17, 2013

Premium HDD Navigation Map Update Process (EMV-N)

Service Category
Audio/Visual/Telematics

Section
Navigation/Multi Info Display

Market
USA

Applicability

Introduction

Lexus models equipped with the Premium HDD Navigation (EMV-N) System require a Special Service Tool (SST) USB drive to update the map, points of interest, Gracenote(R), and system software. The SST is used with all vehicles to deliver the update, however a unique Activation Number is required for each vehicle. Activation Numbers are provided in an Activation Card Number (ACN) pamphlet available through the normal parts ordering system. Use the process described in this bulletin to perform the update.

Parts Information

Warranty Information

Required Tools & Equipment

On-vehicle Data Navigation Update

1. Update Gracenote(R) information using

HINT

Connect a battery charger to the vehicle prior to beginning the process to ensure constant battery voltage.

2. Log into TIS.

3. Log into Navigation Update Wizard.

A. Click on the TIS tab.

B. Click on the Diagnostics tab.

C. Click on the Navigation tab.

D. Re-enter your password.

4. Select Denso from the Select Navigation Manufacturer dropdown.

5. Enter the Activation Card number from the inside of the pamphlet (obtained from parts department).

6. Click Submit.

7. Turn Ignition ON (Ready OFF).

8. Please note the head unit style to determine how to get to the Map Data screen.

A. Press the "INFO APPS" button on the navigation head unit.

B. Press "Menu" on the Remote Touch pad. Then select "INFO/APPS.

9. Press the "Map Data" button on the navigation screen.

10. Record the Map Version and Map Update ID from the navigation screen.

11. Enter navigation data into the Navigation Update Wizard form.

A. Select the correct USB part number (found on the SST packaging; Starts with "LEXD").

B. Input the Map Update ID into TIS

C. Input the Map Version into TIS

D. Enter the VIN

E. Enter the Repair Order Number

F. Click on the Submit button

12. Check off each item after confirming that it is correct. If any of the information is incorrect, click the "Back" button.

13. Click the Confirm button.

14. Note the License Key that was generated. (Print this page if necessary).

15. Insert the "USB Drive - Navigation Update" stick into the USB port of the vehicle (usually located under the navigation head unit, in the center console/armrest, or glove box).

16. Click the "Update Map" button on navigation screen.

17. Click the "Yes" button on the navigation screen.

18. Enter the License Key from step 13.

19. Click on the "OK" button on the navigation screen.

20. Update Navigation Head Unit Software. Click "Yes" on the "Software Update" screen to accept and begin this update.

If the head unit displays the "Map Update" screen, go to step 20.

A. Cycle ignition OFF, then ON (Ready OFF).

B. Allow update to complete (approximately 10 minutes).

C. The head unit will prompt to cycle ignition. Cycle ignition "OFF" and then ON (Ready OFF).

D. Press the "INFO APPS" button.

E. Press the "Map Data" button.

21. The Navigation Map Update will begin automatically.

22. The new map data will be available after you cycle the ignition. Turn the ignition OFF then ON (Ready OFF).