Canada - Body - Power Window Initialization Procedure

L-TCI-3219

September 14, 2012

INITIALIZATION OF POWER WINDOW DURING PDS

Service Category
General

Section
Pre-Delivery Service

Market
Canada





APPLICABILITY:

INTRODUCTION:

As a result of the removal of the DCC fuse, the "one-touch open and close" and "jam protection" functions of the driver's door power window will be inoperative due to loss of the driver's door power window position memory stored in the microcomputer.

Initialize the driver's door power window after installing the DCC fuse in its original location during Pre-Delivery Service (PDS).

NOTE

Any time the battery terminal has been disconnected, each power window MUST be initialized after reconnecting the battery terminal.





WARRANTY INFORMATION:

INITIALIZATION PROCEDURE:





1. Cycle the ignition switch to the "IG-ON" position.

2. Close the driver and passenger doors and verify the quarter windows and retractable hardtop are fully closed.

3. Push "DOWN" the driver's door power window switch and lower the window halfway.





4. Pull "UP" the driver's door power window switch until the window closes, and hold it until the switch stops blinking and remains illuminated.

5. Check for proper operation of the "one-touch open and close" function by fully pushing the switch "DOWN" once and fully pulling the switch "UP" once.

NOTE

Open the door and confirm that the window automatically retracts (lowers) slightly. Confirm that the window automatically returns to the fully closed position when the door is closed. If not, initialization is not complete. Please repeat steps 1 - 5.

6. Repeat steps 1 - 5 for passenger door power window.

© 2012 Lexus, a division of Toyota Motor Sales, Canada