Air Line Fluid Purge

1. Disconnect air line at compressor air drier.

NOTE: Perform this procedure if fluid (water and/or oil) is found in the rear air lines. Purge fluid from air lines and replace affected components.

2. Disconnect the rear LH and RH air lines from the air springs.
3. Connect shop air line to disconnected air line and blow any fluid out.
4. Reconnect the air lines at the RH and LH air springs.
5. Replace the compressor air drier.
6. Reconnect air line at the compressor air drier.
7. Ensure all air line fittings are sealed.