Rear Door Power Window Switch Bezel - Loose

Article No.
99-12-11

06/14/99

INTERIOR TRIM - REAR DOOR - LOOSE POWER
WINDOW SWITCH BEZEL

LIGHT TRUCK:
1998-1999 NAVIGATOR

ISSUE
The rear door power window switch bezel may not stay retained in the door trim panel. This may be due to the metal clip not providing enough positive retention.








ACTION
Replace the window switch bezel (with metal clip (Figure 1)) with a revised Window Switch Bezel (refer to Parts Block for application) (with studs and pal nuts (Figure 2)). Refer to the following Service Procedure for details.

SERVICE PROCEDURE

NOTE
THE SWITCH AND BEZEL ARE NOW SERVICED SEPARATELY. THE OLD SWITCH CAN BE USED WITH NEW BEZEL.

1. Remove rear door trim panel per 1999 Navigator Workshop Manual, Page 501-05-21.

NOTE
FOR NAVIGATORS BUILT ON OR AFTER 2/9/1999, IT WILL BE NECESSARY TO REMOVE THE DOOR TRIM PANEL FROM THE SHEET METAL PRIOR TO REMOVING THE SWITCH BEZEL. USE THE FOLLOWING REVISED REAR DOOR TRIM PANEL PROCEDURE.

a. Remove the end caps located at each end of the door pull handle.

b. Remove the two (2) screws.

c. Remove the rear door handle trim cover.

d. Remove the rear inside door handle bolt.

e. Remove the door trim panel by lifting upward until panel is free.

f. Reach behind the door trim panel to disconnect the electrical connector from the switch.

g. Remove the pal nuts securing the switch and bezel to the door panel (Figure 2).

2. Install switch into new bezel.





3. Install the bezel to the door trim panel opening by securing the pal nuts (5.5 mm - obtain locally if needed) to the studs (Figure 3).

4. Connect the wire harness to the switch and reinstall the door trim panel in reverse order to the procedure followed above.





Parts Block

OTHER APPLICABLE ARTICLES: NONE

WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage

OPERATION DESCRIPTION TIME

991211A Replace Window Switch 0.5 Hr.
Bezel

DEALER CODING
CONDITION
BASIC PART NO. CODE
14529 07

OASIS CODES: 102000, 107000, 205000, 290000