Rear

REMOVAL







1. Remove the RH scuff plate.







2. Remove the RH A-pillar lower trim panel.







3. Disconnect the rear antenna lead-in cable from the front antenna lead-in cable.







4. Remove the RH rear door scuff plate.
5. Remove the RH rear quarter trim.
6. Lower the headliner enough to gain access to the rear antenna cable connection.
7. Disconnect the rear lead-in cable from the antenna cable.







8. Remove the nut from the ground plate.
9. Remove the ground plate and remove the antenna cable ends.

NOTE: The antenna is an integral part of the wiring harness and can not be replaced separately from the harness. Cut the ends off of the old antenna cable and tape the remainder to the wiring harness to prevent noise.

INSTALLATION
1. To install, reverse the removal procedure.

NOTE: When installing the new cable, tape or wire tie the new cable to the wiring harness to prevent noise.