Center Support

Special Tools:

Disassembly
1. Using the (A) O-Ring Tool, remove and discard the (B) direct clutch seal rings. Remove the (C) No. 6 center support thrust washer.





2. Inspect the following for contamination or damage. Clean or replace, as necessary.
- No. 6 center support thrust washer (A).
- Seal ring grooves (B).
- Inner hub diameter (C).
- Outer hub diameter (D).
- Feedbolt threads (E).
- Ball bearing (F).

Assembly
1. Follow the removal procedure in reverse order.
- Lightly lubricate the thrust washer with petroleum jelly to hold it in place during assembly.
- Install new seals.