Cylinder Head Assembly: Specifications

Engine General Specifications

Tightening Specifications

Install the LH and the RH cylinder heads. Loosely install the new bolts.

Note: LH shown; RH similar.

Tighten the RH bolts in three stages, in the sequence shown.
- Stage 1: Tighten to 40 Nm (30 ft. lbs.).
- Stage 2: Tighten an additional 90 degrees.
- Stage 3: Tighten an additional 90 degrees.





Tighten the LH bolts in three stages, in the sequence shown.
- Stage 1: Tighten to 40 Nm (30 ft. lbs.).
- Stage 2: Tighten an additional 90 degrees.
- Stage 3: Tighten an additional 90 degrees.