Front Seat Backrest - 60 Percent
FRONT SEAT BACKREST - 60 PERCENTDisassembly
WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
- If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental restraint system (SRS) must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the 60 percent seat and depower the SRS.
2. Remove the 60 percent seat backrest.
3. CAUTION: Use care when separating the seat backrest covering from the hook-and-loop fasteners to avoid tearing the fastener off the seat foam.
Invert the seat backrest trim cover and remove.
4. Remove the seat backrest foam pad.
Assembly
1. Install the seat backrest foam pad.
2. Install the seat backrest trim cover.
3. Install the 60 percent seat backrest.
4. Install the 60 percent seat and repower the SRS.