Power Window Switch: Service and Repair
WINDOW CONTROL SWITCHRemoval and Installation
Navigator front
1. Lift up on the center console armrest.
2. Remove the center console window control switch panel.
- Remove the pin-type retainer.
3. Disconnect the electrical connectors and remove the window control switch.
- Release the locking tabs.
Expedition front and Expedition passenger rear
NOTE: Driver side Expedition shown, all others similar.
4. Remove the window control switch panel.
5. Disconnect the electrical connector(s) and remove the window control switch.
- Release the locking tabs.
Navigator passenger rear
6. Remove the rear door trim panel.
7. Remove the window control switch from the door trim panel.
All vehicles
8. To install, reverse removal procedure.