Lower

Fig. 1 Rear suspension.:

NOTE: Always replace control arms in pairs. Therefore, if one arm requires replacement, replace the same arm on the opposite side of the vehicle.

1. Remove stabilizer bar if equipped.
2. Position a suitable jack under rear axle, then raise vehicle and support body at rear body crossmember.
3. Lower axle until shock absorbers are fully extended. Support axle with jack stands or a suitable jack.
4. Position a suitable jack under lower control arm rear pivot bolt and remove nut and bolt. Carefully and slowly lower the control arm until all spring tension is relieved, then remove coil spring and insulators.
5. Remove lower control arm front pivot bolt and nut, then remove lower control arm assembly.
6. To reinstall, reverse procedure. Tighten pivot bolts to 135 Nm (100 ft lb) with suspension at normal curb height.