Crown Victoria "A" Pillar Cover

1. Remove windshield exterior moulding using removal tool.

2. Remove the front "B" pillar exterior moulding from the front door opening, 4 screws.

2. Pry off the front drip moulding assembly.

FIGURE 3:

4. Remove the retaining screw at bottom of A pillar cover and remove cover by pulling down and outward. Figure 3.
5. Position new cover and install retaining screw.

6. Install drip and "B" pillar mouldings.

NOTE: If vinyl or padding is loosened, apply Ford Vinyl Roof Adhesive D9AZ-19C525-A or equivalent, and smooth out wrinkles or puckers.