Operation CHARM: Car repair manuals for everyone.

Right Front

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY AND BACKUP POWER SUPPLY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE AND BACKUP POWER SUPPLY MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

1. Disconnect battery ground cable and backup power supply.
2. Disconnect and remove heated windshield relay (if so equipped).





3. Disconnect RH front sensor electrical connector.
4. Remove two nuts attaching RH front sensor to RH fender apron and remove sensor.

Installation
1. Position RH front sensor and wire lead in vehicle and secure sensor to RH fender apron with two nuts. Tighten nuts to 9-14 N.m (7-10 lb-ft).
2. Connect RH front sensor wire lead connector to wiring assembly connector.
3. Install heated windshield relay (if so equipped).
4. Connect backup power supply and battery ground cable.
5. Verify air bag indicator lamp.