Rear Door Window Regulator: Service and Repair

Removal






1. Remove door trim panel and watershed. Doors
2. Prop glass in full-up position.
3. Remove four rivets attaching regulator mounting plate assembly to door inner panel.
4. Slide regulator arm plastic guides out of C-channel, and disconnect power wiring connector lift.
5. Remove window regulator from door.

NOTE: Use access hole in door inner panel for removal/installation.

Installation

1. Install window regulator through the accessible in the rear door and slide regulator arm plastic guides into glass bracket C-channel and equalizer bracket.
2. Install rivets (Part No. 385189-S100)using Heavy Duty Riveter D80L-23200-A or equivalent, or 1/4-20 x 1/2-inch screw and washer assemblies and 1/4-20 nut and washer assemblies to secure regulator mounting plate to door inner panel.

NOTE: Equivalent metric retainers may be used.

3. Cycle glass to ensure smooth operation.
4. Install watershield and door trim panel.