Air Bag Control Module: Service and Repair

Diagnostic Assembly

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY AND BACKUP POWER SUPPLY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE AND BACKUP POWER SUPPLY MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

1. Disconnect battery ground cable and backup power supply.
2. Lower glove compartment down past stops (press in sides).
3. Remove heater duct above glove compartment.
4. Depress monitor retaining tabs and lower monitor from bracket (blue box, two connectors).
5. Disconnect two monitor connectors.

Installation
1. Connect two monitor electrical connectors.
2. Position monitor to bracket and secure with retaining tabs.
3. Install heater duct.
4. Return glove compartment to proper position.
5. Connect backup power supply and battery ground cable.
6. Verify air bag warning lamp.