Rear
REMOVAL1. Remove rear axle shaft.
Fig. 18 Rear toothed sensor ring removal:
2. Install pinion bearing cone remover tool, between axle shaft flange and sensor ring. Ensure recessed portion of inner surface of tool is toward axle flange.
3. Position axle in an arbor press and press axle out of sensor ring.
Fig. 19 Rear toothed sensor ring installation:
INSTALLATION
1. To install, position sensor on axle shaft with recessed side facing inboard.
2. Install pinion bearing cone remover tool, on axle shaft.
3. Position a piece of bar stock on top of axle flange, then press sensor ring onto axle shaft until a 63-65mm (2.48-2.55 in) gap between the face of the sensor ring and face of the flange is obtained.
4. Install axle shaft.