Right Front
RemovalWARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY AND BACKUP POWER SUPPLY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE AND BACKUP POWER SUPPLY MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.
1. Disconnect battery ground cable and backup power supply.
2. Remove air filter assembly.
3. Remove wiring locator from sheet metal.
4. Disconnect RH front sensor electrical connector.
5. Remove three screws attaching RH front sensor to RH radiator support, and remove sensor.
Installation
1. Position RH front sensor and wire lead in vehicle and secure sensor to RH radiator support with three screws. Tighten screws to 4.4-6.0 N.m (38-53 lb-in).
2. Connect RH front sensor wire lead connector to wiring assembly connector.
3. Install wiring locator into hole in sheet metal.
4. Install air filter assembly.
5. Connect backup power supply and battery ground cable.
6. Verify air bag indicator lamp.