Fresh Air/Recirculation Actuator
VACUUM CONTROL MOTOROutside-Recirculating Door Vacuum Motor
Removal
1. Remove the spring nut retaining the outside-recirculating air door vacuum motor arm to the door crank arm.
2. Disengage the vacuum motor arm and washer from the crank arm.
3. Disengage the assist spring and the second washer from the crank arm.
4. Disconnect the white vacuum hose connector from the vacuum motor.
5. Remove two nuts retaining the vacuum motor and the assist spring bracket to the air inlet duct mounting bracket. Remove the vacuum motor and the assist spring mounting bracket.
Installation
1. Position the vacuum motor and the assist spring bracket to the air inlet duct mounting bracket. Install the retaining nuts.
2. Install one of the washers on the crank arm. Install the loop end of the assist spring.
3. Install the second washer and the vacuum motor arm on the crank arm. Secure the two washers, the assist spring and the vacuum motor arm on the crank arm with a new spring nut.
4. Connect the white vacuum hose connector onto the vacuum motor.
5. Check for proper system operation.