Window Operational

Removal

1. Remove door armrest, trim panel and watershield. Doors

2. Remove door glass.

3. Disconnect power motor wiring connector.

4. Remove three 1/4-inch rivets retaining motor bracket to inner panel and two 1/4-inch rivets retaining lower bracket of regulator to inner panel. Use drift to knock out center pins for each rivet. Using a 1/4-inch diameter drill, drill out remainder of rivet. Use care not to enlarge sheet metal holes in the door inner panel.

5. Remove two upper regulator retaining nuts.

6. Remove regulator.


Installation

1. Lubricate regulator mechanism with Teflon(r) Lubricant D2AZ-19590-A (ESB-M1C111-A) or equivalent.

2. Install regulator into access hole in inner panel.

3. Position regulator using upper regulator studs and tabs on motor mounting bracket.

4. Install rivets retaining regulator to door inner panel (1/4-20 x 1/2 inch bolt and 1/4-20 nut and washer assemblies or equivalent metric fasteners may be used as alternates).

5. Install two upper regulator retaining nuts. Tighten to 9-14 N-m (7-10 lb-ft).

6. Install door glass.

7. Adjust glass.

8. Install watershield and door trim panel. Doors