General Specifications

(2) Head Gasket Surface - WT @ 10.0 Minus 2.5 Microns
Head Gasket Surface Finish RZU - 13.5 0.8 TPI 63% MIN.
Re 3.0-3.5 J.80. This ID is obtained using a hand held profilometer.

(3) Time required for plunger to leak down 1.6mm of travel with 222N force and leak down fluid in tappet.

(4) Distance front edge of bearing is installed below front face of cylinder block.

(5) 0.050 undersize add 0.025 to standard thickness.

(6) Pin bore and crank bearing bore must be parallel and in same vertical plane within the specified total difference when measured at the ends of an 203rnm bar, 101.5mm on each side of rod centerline.

(7) Measured at the piston pin bore centerline, at 90 degrees to the pin.

(8) Add 1 quart with filter change.

(13) Piston Bore Diameter

Red - 90.200-90.213

Blue - 90.213-90.226

Yellow - 90.226-90.239

(14) Specification in gauge.