Torque Specifications
| Specific Applications | Jack Screws(16) | - (16) Tighten in two Steps: First step 5 Nm (44 lb-in) Second step 9-11 Nm (80-97 lb-in) |
| Jack Screw Bolts(17) | - (17) Tighten in two Steps: First step 10 Nm (7 lb-ft) Second step 12-23 Nm (14-17 lb-ft) | |
| Camshaft Gear Bolt | 110-130 | |
| Connecting Rod @ Bolt(15) | - (15) Torque in two Steps: First step 25-35 Nm (18-25 lb-ft) Second step Rotate 85-95 degrees | |
| Cylinder Head Bolt(9) | - (9) Torque in 3 Steps: First step 20-30 Nm (15-22 lb-ft) Second step Rotate 85-95 degrees Third step Rotate 85-95 degrees | |
| Damper to Crankshaft Bolt | 155-165 | |
| EGR Valve to Intake Manifold | 20-30 | |
| Exhaust Manifold to Cylinder Head Bolt | 20-30 | |
| Flexplate to Crankshaft | 73-88 Nm | |
| Intake Manifold to Cylinder Head Bolt(11) | 20-30 (11) After assembly retorque with engine hot. | |
| Main Bearings Cap-Bolt(10) | - (10) Tighten in 2 Steps: First step 30-35 Nm (22-25 lb-ft) Second step Rotate 85-95 degrees | |
| Oil Filter Adapter Bolt | 20-30 | |
| Oil Filter to Cylinder Block(12) | - (12) 1/2 turn after gasket contacts sealing surface. | |
| Oil Inlet Tube to Oil Pump Bolt | 8-12 | |
| Oil Pan Drain Plug | 11-16 | |
| Oil Pan to Cylinder Block - Bolt | 20-30 | |
| Oil Pump to Cylinder Block Bolt | 8-12 | |
| Oil Inlet Tube to Main Bearing Cap - Nut | 20-30 | |
| Water Pump to Pulley - Bolt | 20-30 | |
| Spark Plug to Cylinder Head | 9-10 | |
| Alternator to Cylinder Block | 20-30 | |
| Camshaft Cover Bolt | 6-12 | |
| Housing Bolt | 20-30 |