Operation

Operation

To unlock the driver's door, press the UNLOCK button on the transmitter (which is programmed into the module) once. This will also disarm the anti-theft system, if equipped.

To unlock all doors, press the UNLOCK button on the transmitter twice, the second depression must be within five seconds of the first.

NOTE: If more than five seconds have elapsed since the first depression of the UNLOCK button, pressing the UNLOCK button again will only unlock the driver's door.

To unlock the luggage compartment, press the blue TRUNK button on the transmitter once.

To turn on interior lamps and keyhole illumination, press any of the following transmitter buttons:

UNLOCK, TRUNK or PANIC.

To lock all doors, press LOCK button on the transmitter once. This will also arm the anti-theft system, if equipped.

To confirm that doors have locked, press LOCK button again, within five seconds of the first depression. This will beep the horn and lock all doors again.

To activate the personal security alarm, press the red PAN IC button on the transmitter. The horn will beep and parking lamps will flash for a maximum of three minutes.

To deactivate the personal security alarm, press the red PANIC button again or turn the ignition key ON.

NOTE: The remote entry features will not function when the ignition switch is in the RUN or ACCESSORY position.

Programming Transmitter(s)

To program (or re-program) transmitter(s) into the remote / keyless entry module, perform the following steps:

1. Turn ignition switch to ON or ON / ACCESSORY position and momentarily short the two terminals of the Program Connector (J4) (a two-pin connector taped to the wire assembly and accessed by dropping the glove compartment). All doors should lock then unlock. Remove shorting pin.
2. Press any button on transmitter. All doors should lock then unlock, to verify that transmitter has been programmed.

NOTE: If door locks do not respond, press button again (up to three times maximum with the same transmitter). If door locks still fail to respond, go to Pinpoint Test I.

3. Repeat Step 2 to program additional transmitters into the control module (up to four transmitter maximum).
4. Turn ignition OFF. All doors should lock then unlock.
5. Check operation.

NOTE: The remote/keyless entry module erases all previous transmitters from memory when the transmitters are programmed or re-programmed. The remote / keyless entry module can store up to four transmitters in memory.