Keyless Entry Transmitter: Service and Repair
Keyless KeypadTo unlock the driver's door, enter the permanent factory code or the owner's alternate code. This will also disarm Anti-theft system, if equipped.
To unlock the passenger door(s), press the 3/4 button within five seconds of unlocking the driver's door or luggage compartment.
To unlock the luggage compartment, press the 5/6 button within five seconds of unlocking driver's or passenger door(s).
To turn on the interior lamps, lift either front door handle or press any button on the keypad. All illuminated components will light.
To program temporary code, press 1/2 button within five seconds of last command. Enter any alternate five digit code within five seconds of pressing 1/2 key.
To lock all doors, press the 7/8 and 9/0 buttons at the same time. It is not necessary to enter the key code first. This will turn off courtesy lamps and arm Anti-theft system, if equipped.
Programming Transmitter(s)
To program (or re-program) transmitter(s) into the remote / keyless entry module, perform the following steps:
1. Turn ignition switch to ON or ON / ACCESSORY position and momentarily short the two terminals of the Program Connector (J4) (a two-pin connector taped to the wire assembly and accessed by dropping the glove compartment). All doors should lock then unlock. Remove shorting pin.
2. Press any button on transmitter. All doors should lock then unlock, to verify that transmitter has been programmed.
NOTE: If door locks do not respond, press button again (up to three times maximum with the same transmitter). If door locks still fail to respond, go to Pinpoint Test I.
3. Repeat Step 2 to program additional transmitters into the control module (up to four transmitter maximum).
4. Turn ignition OFF. All doors should lock then unlock.
5. Check operation.
NOTE: The remote/keyless entry module erases all previous transmitters from memory when the transmitters are programmed or re-programmed. The remote/keyless entry module can store up to four transmitters in memory.