Cruise Control Servo: Service and Repair

1. Remove screws, then disconnect speed control cable actuator cable from accelerator cable bracket and intake manifold support bracket.
2. Disconnect speed control actuator cable from accelerator cable.
3. Disconnect servo electrical connector.
4. Remove two servo bracket assembly to shock tower retaining nuts.
5. Remove servo bracket and cable, then the two vacuum hoses and electrical connector from servo assembly.
6. Remove two servo to mounting bracket retaining nuts.
7. Remove servo and cable assembly, then the two cable cover to servo retaining nuts.
8. Pull off cover and remove cable assembly from servo.
9. Reverse procedure to install, torque retaining nuts to 45-65 inch lbs.