Operation CHARM: Car repair manuals for everyone.

Accelerator Cable

REMOVAL and INSTALLATION

1. Remove engine air cleaner intake tube and duct.

2. Using a suitable tool, remove cable snap-in nylon bushing from accelerator pedal and shaft arm.

3. Remove cable housing from dash panel by depressing two vertical snap-in tabs and pushing outward from inside passenger compartment.

4. Remove speed control actuator cable from accelerator cable, if so equipped.

5. Disconnect accelerator cable at throttle body lever by inserting a screwdriver between accelerator cable and throttle body lever and giving a twist.

6. Remove accelerator cable bracket retaining screw. Remove accelerator cable from accelerator cable bracket slot.

7. To install, reverse Removal procedure and ensure that accelerator cable motion is not restricted. Tighten~retaining screw to 8-12 Nm (71-106 lb in).