System Reactivation Procedures

WARNING: THE AIR BAG SIMULATOR(S) MUST BE REMOVED AND THE AIR BAG(S) RECONNECTED WHEN THE SYSTEM IS REACTIVATED.

1. Disconnect positive battery cable.
2. Remove Rotunda Air Bag Simulator 105-00010 or equivalent from air bag terminals on clockspring assembly and passenger air bag (if equipped) harness connector if connected.
3. Reconnect driver air bag connector.





4. Position driver air bag on steering wheel and secure with four nut and washer assemblies (10mm). Tighten nut and washer assemblies to 4-5.6 N.m (36-49 lb-in).
5. Reconnect passenger air bag connector. Tighten bolts to 7.6-10.4 N.m (68-92 lb-in) and screws to 2.7-3.7 N.m (24-32 lb-in).
6. Close glove compartment door.
7. Connect positive battery cable.
8. Verify air bag indicator.