Air Bag Control Module: Service and Repair

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AN POSSIBLE PERSONAL INJURY, THE POSITIVE BATTERY CABLE MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY

1. Disconnect positive battery cable.
2. Remove two screws retaining steering column opening cover to instrument panel and remove cover.
3. Remove four bolts retaining bolster and remove bolster.
4. Disconnect diagnostic monitor electrical wiring connectors.
5. Remove two screws retaining diagnostic monitor and bracket assembly to instrument panel brace and remove assembly.
6. Remove two screws retaining monitor to bracket.

Installation
1. Position diagnostic monitor to bracket and install two retaining screws.
2. Position diagnostic monitor and bracket on instrument panel and install two retaining screws.
3. Connect electrical wiring connector to the diagnostic monitor.
4. Position bolster on instrument panel and install four retaining bolts. Tighten bolts to 7-11 N.m (5-8 lb-ft).
5. Position steering column opening cover on instrument panel making sure clips are installed in retaining holes. Install two retaining screws.
6. Connect positive battery cable.
7. Verify air bag indicator.