General Specifications

(1) Newly Installed - Refers to the condition of the "NEW" drive belt before the engine has made no more than one rotation and before the belt has had a chance to stretch or seat into the pulley grooves.
(2) Head Gasket Surface- WT @ 10.0 Minus 2.5 Microns Head Gasket Surface Finish RZU - 13.5 0.8 TPI 63% MIN. Re 3.0-3.5 J.80. This ID is obtained using a hand held profilometer.
(3) Time required for plunger to leak down 1.6mm of travel with 222N force and leak down fluid in tappet.
(4) Distance front edge of bearing is installed below front face of cylinder block.
(5) 0.050 undersize add 0.025 to standard thickness.
(6) Pin bore and crank bearing bore must be parallel and in same vertical plane within the specified total difference when measured at the ends of an 203mm bar, 101.5mm on each side of rod centerline.
(7) Measured at the piston pin bore centerline, at 90 degrees to the pin.
(8) With filter change.
(13) Piston Bore Diameter
Red - 90.200-90.213 Blue - 90.213-90.226
Yellow -90.226-90.239
(14) Specification in gauge.