Front Crash Sensor

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE POSITIVE BATTERY CABLE MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.





1. Disconnect positive battery cable and wait one minute for backup power supply energy to be depleted.
2. Disconnect RH or LH front sensor electrical connector.
3. Remove two screws retaining RH or LH front sensor at side of grille opening reinforcement bracket and remove sensor.

Installation
1. Position RH or LH front sensor and wire lead in vehicle and secure sensor to RH or LH side of grille opening reinforcement bracket with retaining screws. Tighten screws to 10.2-13.8 N.m (91-122 lb-in).
2. Connect RH or LH front sensor wire lead connector to wiring assembly connector and secure wiring retainer.
3. Connect battery positive cable.
4. Verify air bag indicator.