With Digital Cluster

1. Disconnect battery ground cable.
2. Unsnap center molding on righthand and lefthand sides of instrument panel.
3. Remove steering column cover and shroud.
4. Remove knobs from auto dim and auto lamp, if equipped.
5. Remove 13 instrument panel retaining screws, then pull panel out.
6. Move shift lever to "1" position for easier access.
7. Disconnect electrical connectors from warning module, switch module and center panel switches, if equipped.
8. Remove instrument panel.
9. Disconnect electrical connector from front of cluster.
10. Disconnect PRNDL assembly from cluster, by carefully bending bottom tab down and pulling assembly forward.
11. Pull cluster out and disconnect electrical connector.
12. Remove instrument cluster.
13. Reverse procedure to install.