AA Tests
AA1 STEP 1
- STAR Tester 007-0004 or SUPER STAR II Tester 007-0041A must be used for this procedure. SUPER STAR Tester 007-00019 may not be used.
- Remove all extra loads from luggage and passenger compartments.
- Set STAR Tester as follows:
STAR: EEC/MCU Setting
SUPER STAR II: EEC/MCU Setting, FAST codes
- Turn ignition switch OFF.
- Turn air suspension switch (RH side of luggage compartment) OFF, then ON.
- Remove RH luggage compartment trim panel.
- Connect STAR Tester to diagnostic connector.
NOTE:
Ensure STAR test button is in HOLD (up) position before connecting to vehicle.
- Start engine. If engine cannot be started, connect battery charger to maintain battery level and turn ignition to RUN.
- Wait at least two seconds, then depress STAR Tester button so it remains in the TEST (down) position.
- Within 20 seconds, a STAR CODE 10 should be displayed.
STAR CODE 10 displayed
System is in AUTO Test Mode. GO to AA2.
STAR CODE 80 displayed
GO to Pinpoint Test M. M
No STAR CODES displayed
GO to Pinpoint Test N. N
AA2 STEP 2
- STAR CODE 10 will be displayed for up to two minutes.
- DO NOT put any weight on vehicle while STAR CODE 10 is displayed.
- When Auto Test is complete a STAR CODE 12 (Auto Test passed) or STAR CODE 13 (Auto Test failed) will be displayed.
- With STAR CODE 12 or 13 displayed:
-- Open and close all four doors sequentially.
-- Turn steering wheel 1/4 turn in both directions.
NOTE:
The above manual inputs can be done in any sequence.
- Release STAR TEST button to HOLD (up) position.
- Wait two seconds and depress button to TEST (down) position.
- Within 20 seconds STAR CODES will be displayed.
NOTE:
The STAR CODES will be displayed for about 15 seconds each. After all codes have been displayed, the codes will be repeated. The STAR CODES will continue to repeat as long as the STAR tester button is in the TEST (down) position.
- Is STAR CODE 11 displayed?
Yes
Vehicle passes. EXIT diagnostics by disconnecting STAR tester and turning ignition off.
No
RECORD STAR CODES. REFER to <(Air Suspension STAR CODE)) chart for Pinpoint Tests for STAR CODES displayed. DO NOT disconnect or turn off STAR Tester, ignition switch or air suspension switch. GO to Pinpoint Tests for STAR codes displayed.