Engine - No Crank Condition

Article No.
94-18-3

09/07/94

NO CRANK - POSSIBLE CORROSION AT STARTER SOLENOID ON VEHICLES WITH 4.6L ENGINE

FORD:
1992-94 CROWN VICTORIA

LINCOLN-MERCURY:
1991-94 TOWN CAR
1992-94 GRAND MARQUIS

ISSUE:
Some vehicles may exhibit a "NO-CRANK" condition due to corrosion at the starter solenoid connector.

ACTION:
Replace the corroded connector with a service wiring and connector assembly. Applying di-electric grease, along with replacing the wiring and service connector, to the terminal connector will aid in corrosion protection.

DETAILED SERVICE PROCEDURE

1. Disconnect negative battery cable.

2. Remove the connector from the solenoid by firmly grasping the connector and pressing the external detent release (if so equipped) and pulling.

CAUTION:
DO NOT PULL ON THE WIRE BECAUSE THIS WILL DAMAGE THE TERMINAL.

3. DO NOT SAND OR FILE THE TERMINAL. Brush Di-Electric Grease (D7AZ-19A331-A, or equivalent) onto the terminal.





4. Remove harness retainer from portable hole on battery cable. Figure 1.

5. Using scissors, carefully cut the protective sleeving 4" (100 mm) back from the connector.

6. Push sleeving back and cut wire 8" (200 mm) back from the connector end.

7. Strip wire 5/16" (8 mm).





8. Insert wire into butt connector of Service Wire and Connector Assembly (F4VY-14A411-A) and crimp using tool for pre-insulated crimps. Figure 2.

9. Heat splice with heat gun until tubing shrinks and adhesive flows from each end.

10. Pull sleeving back over the splice and up to the back of the connector.

11. Fully tape over the slit and wire up to the back of the connector.

12. Replace harness retainer and tape it 6" (150 mm) from the end of the connector.

13. Assemble connector to starter. Insert harness retainer into floating hole on battery cable.

14. Install negative battery cable.

PART NUMBER PART NAME CLASS

F4VY-14A411-A Wiring And Connector Assembly AG

OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage

OPERATION DESCRIPTION TIME
941803A Repair Connection 0.6 Hr.

DEALER CODING
BASIC PART NO. CONDITION CODE
14A411 X4

OASIS CODES: 201100, 203200, 601300