Electrical Test

1. Use a 12 volt test lamp to test the one touch control module.

2. With the ignition switch in the accessory position, connect a test lamp between pin 5, Circuit 57 (Bk), and pin 3, Circuit 400 (LB/Bk). The lamp should light.

3. With the test lamp connected to pin 3, Circuit 400 (LB! BK). Connect the other end of the test light to:

^ Pin 1 Circuit 903(R). The lamp should light.

^ Pin 2, Circuit 226 (WI Bk). The lamp should light.

^ Pin 4, Circuit 227 (Y). The lamp should light.

4. With the one touch control module removed from the vehicle, check continuity between pins 1, Circuit 903(R) and 2, Circuit 226 (W/Bk). The lamp should light.

5. Check continuity between pins 1, Circuit 903 (R) and 3, Circuit 400 (LB/Bk). The lamp should not light.