XB62 - Check ACP SIG RTN For Short to Power

- Key "OFF".

- A/C Pressure (ACP) sensor disconnected.

- Disconnect Variable Control Relay Module (VCRM). Inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.

- Key "ON".

- Measure voltage between the ACP VREF circuit at the ACP sensor vehicle harness connector and the battery negative post.

- Key "OFF".

- Was the voltage less than 1.0 volt?

Yes -- Replace VCRM. Reconnect all components. Clear continuous memory. Clearing Diagnostic Trouble Codes

Attempt to reset Diagnostic Trouble Code (DTC) 579 (Refer to XB52 for procedure only). XB52 - Clear and Attempt to Regenerate DTC

Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)

No -- Service ACP VREF circuit short to power. Reconnect all components. Clear continuous memory. Clearing Diagnostic Trouble Codes

Attempt to reset DTC 579 (Refer to XB52 for procedure only). XB52 - Clear and Attempt to Regenerate DTC

Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)