Test Notes

NOTE: You should enter this Pinpoint Test only when directed here.

REMEMBER
This Pinpoint Test is intended to diagnose the following:
- HO2S/Heater
- HO2S Connections
- Vacuum Systems
- Fuel Injector(s)
- Harness Circuits: HO2S GND, HO2S, INJ 1-8, VPWR and SIG RTN
- Powertrain Control Module (PCM)

DESCRIPTION
For additional information on the Heated Oxygen Sensor (HO2S), refer to Description and Operation / EEC-V Software and Hardware / PCM Related Inputs.

For additional information on the Heated Oxygen Sensor (HO2S) Monitor, refer to Description and Operation / On Board Diagnostics System Monitor.

WARNING:
PROBING OR PIERCING WIRING INSULATION IS NOT PERMITTED AND MAY ALLOW WATER ENTRY, CAUSING CORROSION AND SHORTING WHICH MAY RESULT IN HO2S FAILURE.