Rear Window Moulding Fit

Intermittent noise from the rear window (backglass) typically described as a "buzz" or "fluttering," and usually occuring at speeds above 97 km/h (60 mph) or when encountering air turbulence from a passing vehicle, may be exhibited. This noise may be caused by a loose backglass moulding and can be repaired using the following procedure.

1. Carefully pull upward on the backglass moulding along the top edge of the rear window.

2. If the moulding pulls out at any point, this is the source of the backglass windnoise and sealer must be used to repair this vehicle.

3. At the point(s) where the moulding pulls out, work Silicone Sealer (F6AZ-19562-AA), or equivalent meeting Ford specification WSE-M4G323-A6, under the moulding and securely attach the moulding to the backglass.