Ignition Control Module: Service and Repair

REMOVAL
1. Disconnect battery ground cable.

Ignition Control Module:

2. Remove LH front shock absorber strut cover cup retaining screws and remove front shock absorber strut cover cup.
3. Disconnect ignition control module electrical connector by pushing down on the connector finger ends while grasping the connector body and pulling away from the Ignition Control Module (ICM).
4. Remove two ignition control module retaining screws and remove ignition control module from ignition control module bracket.

INSTALLATION
1. Position ignition control module to ignition control module bracket and install retaining screws. Tighten to 2.7-3.7 Nm (24-32 in lb).

NOTE: Locking the connector is important to ensure sealing of the connector and ignition control module interface.

2. Connect ignition control module electrical connector by pushing until connector fingers are locked over locking wedge feature on ignition control module.
3. Position front shock absorber strut cover cup on front fender apron and install retaining screws. Tighten retaining screws securely.
4. Connect battery ground cable.