Test Notes

NOTE: You should enter this Pinpoint Test only when directed here.

REMEMBER
Preliminary checks must be performed before continuing this Pinpoint Test.

CHECK:
- Electrical connections
- Vacuum leaks
- Fuel level and quality
- Ignition wiring connections
- Air intake filters, tubes and gaskets
- Aftermarket alterations
- Basic engine (valves, timing, etc.)

DESCRIPTION
This pinpoint test contains instructions for isolating an intermittent fault. It combines the use of a Scan Tool with a Breakout Box (BOB), a fuel psi gauge, vacuum gauge, DVOM, Transmission Tester and Ignition Tester Actual values can be compared to typical values listed in the Diagnostic Reference Values to aid in finding the fault. Also refer to Intermittent Diagnostic Techniques, for further help in isolating and repairing the fault.

If available, the Service Bay Diagnostic System (SBDS) can be used for Intermittent Diagnostics. Refer to Diagnostic Tools for additional information on SBDS.

WORKSHEET FOR ROAD TEST PROCEDURE






NOTE: Typical values can be compared to the actual values obtained during the road test procedure.

Use the Worksheet for Road Test Procedure to list the typical values from the Diagnostic Reference Values, Normal Scan Data Values - Includes Pids