Transmission Position Sensor/Switch: Adjustments

1. Remove nut securing manual control lever to Transmission Range (TR) sensor.
2. Shift manual control lever to NEUTRAL position. Remove manual control lever from manual control lever shaft.
3. Loosen two TR sensor retaining bolts.
4. Align TR sensor slots using TR Sensor Alignment Tool (MLPS Alignment Tool) T92P-70010-AH.
5. Tighten retaining bolts to 9-12 N-m (7-9 lb ft).
6. Install nut retaining manual control lever to TR sensor. Tighten to 12-16 N-m (9-11 lb ft).