Torque Specifications

Alternator Brackets To Cylinder Block 15-22 ft lb
Camshaft Bolt 81-95 ft lb
Camshaft Cover Bolt 6-9 ft lb
Camshaft Sprocket Bolt 81-95 ft lb
Connecting Rod Bolt 18-24 ft lb [01]
Cylinder Front Cover Bolt 15-22 ft lb
Cylinder Head Bolt [02]
EGR Valve To Intake Manifold 15-22 ft lb
Exhaust Manifold To Cylinder Head Bolt 15-22 ft lb
Exhaust Pipe To Exhaust Manifold 20-30 ft lb
Front Engine Cover Bolts 15-22 ft lb
Front Engine Mount Attaching Bolts 45-59 ft lb
Front Engine Mount Through Bolts 15-22 ft lb
Intake Manifold To Cylinder Head Bolt [03]
Oil Inlet Tube To Main Bearing Cap 15-22 ft lb
Oil Inlet Tube To Oil Pump Bolt 6-9 ft lb
Oil Pan Drain Plug 8-12 ft lb
Oil Pan To Cylinder Block 15-22 ft lb
Oil Pump To Cylinder Block 6-9 ft lb
Pulley To Crankshaft [04]
Rear Engine Mount Attaching Bolt 50-70 ft lb
Rear Engine Mount Attaching Nut 35-50 ft lb
Spark Plug 7-8 ft lb
Thermostat Housing 15-22 ft lb
Upper Intake Manifold to Lower Intake Manifold (IMRC) 71-89 in lb [05]
Water Pump To Cylinder Block 15-22 ft lb
Water Pump To Pulley Bolt 15-22 ft lb

[01] -- Rotate an additional 85-90 degrees.
[02] -- Tighten in three steps: First, torque to 27-32 ft lb. Second, rotate bolts an additional 85-95 degrees. Third, rotate bolts an additional 85-95 degrees.
[03] -- Hand-tighten all 20 fasteners. Tighten fasteners 5, 7, 9, and 11 to 9-11 ft lb. All other fasteners tighten to 13-16 ft lb. Then tighten all fasteners in numerical sequence by rotating an additional 85-95 degrees.
[04] -- Tighten in four steps: First, torque to 66 ft lb, then loosen one full turn. Torque to 35-39 ft lb, then tighten an additional 85-95 degrees.
[05] -- Rotate an additional 85-95 degrees.