Idle Speed/Throttle Actuator - Electronic: Service and Repair

REMOVAL
1. Disconnect battery ground cable.

NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

2. Disconnect the idle air control valve connector from the engine control sensor wiring.
3. Remove the idle air control valve retaining bolt and stud bolt.
4. Remove the Idle Air Control (IAC) valve.
5. Remove and discard idle air control valve gasket.

INSTALLATION

NOTE: If scraping is necessary, do not damage IAC valve or intake manifold-to-idle air control valve gasket surfaces or drop material into intake manifold.

1. Clean IAC valve gasket mating surfaces.
2. Using a new gasket, install IAC valve.
3. Tighten retaining bolt and stud bolt to 8-12 Nm (71-106 lb in).
4. Rotate bolt and stud bolt an additional 85-95 degrees (clockwise, two places).
5. Connect battery ground cable.