Glass Panel Height

The correct position of the glass to the roof is as follows:
- Front Corners: Flush to 1 mm (0.039 inch) below roof.
- Rear Corners: Flush to 1 mm (0.039 inch) above roof.

1. Cycle glass from full open to full closed position.
2. Remove three roof sliding panel opening shield retaining screws along front of the opening inside of vehicle and slide roof sliding panel opening shield and sunshade fully rearward to expose six glass retaining screws (three each side).
3. Loosen six glass retaining screws. Then tighten until snug but not to specification.
4. To adjust only the front of glass, loosen the center and front screws. To adjust only the back of the glass, loosen the center and rear screws.
5. To check height setting, open the glass about 101.6 mm (4 inches); then return to the closed position.
6. Tighten the glass retaining screws to 0.8-1.5 Nm (7-13 lb-in).
7. Slide roof sliding panel opening shield forward and replace three retaining screws.
8. Close sunshade if desired.