Fuel Filter: Service and Repair
REMOVAL1. Perform fuel pressure release procedure.
2. Remove push connect fittings at both ends of fuel filter and base.
3. Remove fuel filter and base from fuel filter bracket by loosening mounting clamp enough to allow fuel filter and base to pass through.
INSTALLATION
1. Install fuel filter and base in fuel filter bracket, making sure of proper direction of flow as noted earlier. Position fuel filter and base against tab at lower end of fuel filter bracket.
NOTE: The flow direction arrow should be positioned forward and downward to make sure of proper flow of fuel through replacement fuel filter and base.
2. Install push connect fittings at both ends of fuel filter and base.
3. Tighten mounting clamp to 1.7-2.8 Nm (15-24 lb in).
4. Start engine and inspect for leaks.