Ignition Switch: Service and Repair

REMOVAL
1. Disconnect battery ground cable.
2. Remove LH instrument panel steering column cover.
3. Disconnect the ignition switch electrical connector.
4. Rotate ignition switch lock cylinder to the RUN position.
5. Remove the two screws retaining ignition switch.
6. Disengage the ignition switch from the actuator.

INSTALLATION

NOTE: A new replacement ignition switch will be set in the RUN position as received.

1. Adjust the ignition switch by sliding the carrier to the ignition switch RUN position.
2. Make sure that the ignition switch lock cylinder is in the RUN position. The RUN position is achieved by rotating the ignition switch lock cylinder approximately 90° from the LOCK position.
3. Install the ignition switch. It may be necessary to move the ignition switch slightly back and forth to align the ignition switch mounting holes with the column lock housing threaded holes.
4. Install retaining screws. Tighten to 6-8 Nm (53-70 inch lbs.).
5. Connect electrical connector to ignition switch. Tighten connector screw to 0.9-1.1 Nm (8-9 inch lbs.).
6. Install LH instrument panel steering column cover.
7. Connect battery ground cable. Check ignition switch for proper function, including START and ACC positions. Also, make sure that the steering column is locked in the LOCK position.